|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
|
||||
|
||||
|
Re: Mounting Sprockets to the Rover Wheels
I like to use a 10-32 bolt that puts about 1 inch into the wheel. we run a tap in about .75 inch. The last .25 without threads makes it nice and tight.
I have just run them in without tapping but then they can't be disassembled without the threads getting screwed up. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Press release: Nypro makes the rover wheels! | Elgin Clock | Kit & Additional Hardware | 1 | 12-01-2009 12:01 |
| Rover Wheels | neoshaakti | Kit & Additional Hardware | 11 | 09-01-2009 14:34 |
| Cost of Rover Wheels | Boco Gear | General Forum | 3 | 08-01-2009 16:10 |
| Mounting two output sprockets on andyMark :confused: | EduardoVemny | Motors | 5 | 10-01-2008 21:37 |
| mounting the wheels | Stormhammer | Technical Discussion | 8 | 28-01-2005 14:41 |