Can we cut holes in the bumper plywood for the bolt heads?

markulrich · #1 19-01-2009, 14:31

My team assembled the 2009 Drive Base as instructed in the C-Base-User-Guide. The heads of the bolts used as axles stick out of the sides, so we were planning on cutting holes in the bumper plywood where the bolts are and mounting the bumpers against the C-channel.

I'm sure that this isn't the purpose of R08(L)

Quote:

The BUMPERS must be fixed to the BUMPER PERIMETER.

but technically it seems that if a string was wrapped around at the height of the bolt heads then we would need to have a space the width of 1 bolt head between the C-channel and plywood, which would be unnecessarily complex and not (I think) the intention of R08. What do you think? Have I misread the rule? Is this a question for the GDC?

Thanks!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can the robot extend outside of the bumper zone.	markulrich	Rules/Strategy	15	08-01-2009 08:21
Building the kitbot frame- mate the holes?	Bryan Herbst	SolidWorks	6	11-05-2008 13:44
Making your own plywood for the bumpers	BeyondRamo	General Forum	4	28-02-2008 20:02
can we cut holes in bumpers?????????????	robouser72	General Forum	3	04-02-2008 18:38
How to cut flat sided holes for Globe and Door motor	Max Lobovsky	Motors	8	13-01-2005 14:09