|
|
|
 It's not about a team having lots of money to spend to travel the world to share FIRST but how the team draws the world into their FIRST experience. - Steve W [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It's not about a team having lots of money to spend to travel the world to share FIRST but how the team draws the world into their FIRST experience. - Steve W [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Code Base
OK to avoid creating another thread, and its similar in nature anyway:
How the fork do I set up the connections to download code to the robot? The guide is VERY VERY vague in this, as it just says 1. Download 2. Reboot [facepalm] Do I have to set up cables through the drivers sation then to the cRIO? Or can I just go straight from the laptop to the cRIO? And I assume the IP on the laptop has to be the 10.xx.yy.6 IP in order to download? 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2009 base C/C++ code? | Maxpower57 | Programming | 15 | 24-10-2008 21:02 |
| Circle base vs. Rectangle base | Pelicano234 | Technical Discussion | 13 | 15-01-2008 16:49 |
| Looking for Base Code | Eric W. Jones | Programming | 2 | 30-10-2006 18:54 |
| Knowledge Base | Leon Machado IV | Programming | 15 | 02-08-2005 12:24 |
Hybrid Mode
