Ball Bearings on PVC - Chief Delphi

We make ourselves better by lifting others and standing on their shoulders, not by knocking them down. - Taylor [more]

		Chief Delphi > Technical > Technical Discussion
Ball Bearings on PVC

Thread Tools

Rate Thread

Display Modes

19-01-2009, 20:50

KTjen2967

Registered User

FRC #2967

Join Date: Jan 2009

Location: Georgia

Posts: 2

KTjen2967 is an unknown quantity at this point

Ball Bearings on PVC

Will a standard 608 bearing -- approximately 7/8 of an inch -- fit into any type PVC pipe? In other words, has anyone used PVC with skate bearings at all?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ball Bearings	Mrtrom	General Forum	3	30-01-2008 18:26
Purchasing Ball Bearings	FIRST JerseyKid	Kit & Additional Hardware	7	30-04-2007 09:11
Where to buy Ball Bearings?	ThatIndianKid89	Kit & Additional Hardware	3	20-01-2007 15:59
Threaded rod through ball bearings	Madison	Technical Discussion	38	03-01-2007 01:23
Drills: The ball bearings are gone?	BobbyG	Motors	0	21-01-2003 23:57

All times are GMT -5. The time now is 18:57.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.