FRC Robot Boot-up Deployment (failed to deploy)

[mgurgol]

I am running the Advanced project in Labview, and cannot set the built code to run at startup.

I am connecting from my PC with the cross-over cable to the cRio.
The build properties:
Information tab
Build Specification name:FRC Robot Boot-up Deployment
Target filename: startup-rtexe
Local destination directory: C:\robot
Target destination directory: c:\ni-rt\startup
Build specificaton description:Advanced 4 motor drive

Robot_main is selected in the Source Files tab.

I have been able to deploy the built executable once about a week ago, but I can no longer deploy code to 'run as Startup'

I am able to run the Robot Main through Labview and everything works great, but I just cannot deploy the newly built application.

IP address of the cRio: 10.10.94.2
IP address of the PC: 10.10.94.6

When I attempt to run as startup, it gives me a warning page saying that some vi's will be refreshed by this procedure, which should be fine since I am replacing code in the cRio.

I then get a list of files that were downloaded to the cRio, along with a failure message (deploy failed). If I scroll up the list, I see the message:
FRC Robot Boot-up Deployment (failed to deploy)

Has anyone seen this error?
Is there a log file somewhere that would tell me why it failed to deploy?

Any help would be appreciated.