|
|
|
 Dave Lavery just responded to one of my posts. I think that I might die. - Karibou [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Dave Lavery just responded to one of my posts. I think that I might die. - Karibou [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
20-01-2009, 22:45
|
|||||
|
|||||
|
Re: How to wire included sensors
You can use PWM cables and just solider them on. The encoder uses digital inputs not the analog. The Gyro and accelerometer use the analog inputs. Open the examples in Labview for each of these sensors and study them to test your sensors and knowledge.
The encoders attach directly to the machined end of the drive shaft on the Toughbox. You can buy mounts for them for $4 each at andymark.biz. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How To Wire The Encoder | JamesByrne | Electrical | 6 | 19-01-2009 13:15 |
| How to wire solenoid valves???????? | JCODER | Pneumatics | 3 | 31-01-2008 20:11 |
| Minimum Gauge Wire for Sensors? | psquared89 | Electrical | 2 | 05-02-2006 15:26 |
| How do you wire ADXRS150EB gyro? | MaxM | Electrical | 2 | 16-02-2004 13:43 |
| How to wire a 40 Amp Breaker? | dez250 | Electrical | 6 | 09-09-2003 11:17 |
Threaded Mode