|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
|
|||||
|
|||||
|
Re: 1726 Beginning Week Three
Well...it maybe could...but we did use the lathe for some parts, like making the bearing holes in the roller end caps, and making shaft size adapters for the sprockets onto the transmission and motor shafts, and the output shaft for the Fisher Price little gearbox we made.
I think everything except that output shaft could be made without the lathe, if you were good at drilling holes into round things, and getting them properly centered. Last edited by MrForbes : 21-01-2009 at 00:22. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MOEmentum FYI - Week 3: It's Week Three Already?!? | Mr MOE | General Forum | 0 | 18-01-2009 19:23 |
| week 1: Three Things I've Learned | Jeremiah Johnson | General Forum | 55 | 04-03-2008 00:36 |
| pic: 1726 week 4 | TheOtherGuy | Extra Discussion | 29 | 04-02-2008 00:36 |
| Only 1 week until the beginning of the 2007 DARPA Urban Challenge in VictorVille, CA | Bongle | General Forum | 14 | 31-10-2007 11:08 |
| beginning of a match | Jess1513 | Rules/Strategy | 2 | 10-02-2005 22:05 |