Issue with debugging/running code on cRio

[adamm]

My team ran across the same error you did at the beginning of the build season. The code would build in WindRiver, upload to the cRIO, and the DS would still read "No Code." I know our team was able to fix this issue, but I cannot remember what we did (Sorry). Make sure you have the updated version of LabVIEW or WindRiver and have flashed the cRIO with the correct firmware.

Also, try bypassing the wireless router/radio and plug port 1 on cRIO directly into port 1 on the DS and the computer to port 2 on the DS. There could be a chance that the radios are dropping packets, but its not likely.

I will ask around my team to see if they have any ideas or remember what we did.

[eatbuckshot]

using windriver right?

We have the EXACT same problem as you described.

[Jetweb]

we have been using the cRio with wind river successfully.

first thing i would do is download the latest cRio update and re-image the Rio for wind river just to make sure it doesn't think your using labview.

then check and make sure your downloading the right file from wind river by going to Window->properties (or something close to that) click on the FIRST downloader options and check the team number and make sure your pointing to the correct .out file(i have gotten the same error your getting by downloading the wrong file)

and remember you have to un-deploy -> download -> and then reboot the cRio before the downloaded code will run.

also make sure you set your team number right on the driver station and have all the correct ip's on the gaming adapter (radio), rougher, cRio and the computer you are using is not in conflict with any of them.


Tip:
it is more convenient to use the debug feature so the code will run without a reboot.

good luck,