|
|
|
 They may call us geeks and nerds, but deep down under that prejudice they know they want to be the hard-core, sleep-deprived, hand drill-toting, robot builders we know we are! - vijay24 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Digital Outputs on the Driver Station with C/C++
Quote:
 I'm sure you just called them "inputs" by mistake. Last edited by Mark McLeod : 23-01-2009 at 08:47. 
|
|
#2
23-01-2009, 08:46
|
||||
|
||||
|
Re: Digital Outputs on the Driver Station with C/C++
Quote:
I should also note that we hooked the LEDs to the robot's digital outputs and had great success with that. But since we want some driver feedback that isn't just a laptop on the dashboard port, we want to use the digital outputs.
|
|
#3
23-01-2009, 10:15
|
|||||
|
|||||
|
Re: Digital Outputs on the Driver Station with C/C++
I believe you may have to update the dashboard to get this to take effect.
The set outputs have to be transmitted back to the DS as part of the periodic packet transmission and there might be some interdependency there. P.S. I don't know though. I haven't played with this particular path yet. I'll give it a try later if I can. Last edited by Mark McLeod : 23-01-2009 at 10:47.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using driver station digital inputs | Japper | FRC Control System | 6 | 19-01-2009 20:01 |
| Flashing Driver Station Digital Input | MacGyver1718 | FRC Control System | 3 | 15-01-2009 19:22 |
| Timing with the Driver Station | Zorkinian | Programming | 6 | 10-01-2009 09:42 |
| Help with updating firmware on Driver Station | urg8rb8 | FRC Control System | 3 | 28-12-2008 02:53 |
| Interrupt on driver station digital input | Nameless | Programming | 9 | 04-12-2008 16:55 |
Hybrid Mode
