|
|
|
 I hope you realize that by starting this thread you have earned yourself a permanent place at the "WOEWITWISTFT" ("What On Earth Was I Thinking When I Started THAT FIRST Trend?") table. It's members are few, but the conversation is the most honest and amusing in the entire place. ;) - Jessica Boucher [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
LCD Interfacing via Driver Station
Our team has a serial interfaced LCD we would like to connect to a digital output on our driver station for diagnostics. I've interfaced such devices with Arduino controllers where you can specifically use a digital pin as a serial port and write to it...is there any easy way to do this in LabView?
|
|
#2
24-01-2009, 19:32
|
|||||
|
|||||
|
Re: LCD Interfacing via Driver Station
Our control of the Driver Station digital output pins is not fast enough (50Hz) to use them for serial communication. It works on a processor output pin, because we can change the state of the pin very fast.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver Station Login | Mr-Shutter | FRC Control System | 2 | 12-01-2009 23:36 |
| cant get NXT to connect to controller station via bluetooth | cougarbotics | FIRST Tech Challenge | 5 | 04-12-2008 00:19 |
| interfacing via wifi? | ratcateme | FRC Control System | 7 | 19-08-2008 02:28 |
| Interfacing robot with LCD | keen101 | Programming | 17 | 18-01-2008 16:23 |
| Interfacing with LCD to debug | keen101 | Electrical | 15 | 18-01-2008 13:13 |
Linear Mode
