|
|
|
 If I had a mul-let
then I'd look like Andy Baker used to
and that would be ba-ad,
really ba-ad. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If I had a mul-let
then I'd look like Andy Baker used to
and that would be ba-ad,
really ba-ad. - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
24-01-2009, 10:00
|
|||
|
|||
|
Re: Digital Sidecar Not Working
The LED pattern (5V on, 6V and battery off) indicates that you are not getting power from the battery to the DSC. Check your breaker and your wiring. Most common issue to cause this is grabbing the insulation instead of the copper in one of the wago connectors.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Digital Sidecar Problems | cabbagekid2 | FRC Control System | 13 | 31-01-2009 17:23 |
| Fusing for Digital Sidecar (was: HIZZELP) | KilroyLaxer | FRC Control System | 4 | 15-12-2008 20:44 |
| p2 not working? | Lone_Wolf92c | Programming | 5 | 22-02-2008 08:49 |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| Camera not working | st1nkm4n | Programming | 0 | 31-01-2006 19:23 |
Threaded Mode