|
|
|
 The code is hopefully pretty self-documenting, but I haven't had time to comment it (kinda trying to build a robot at the moment). - RyanCahoon [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| The code is hopefully pretty self-documenting, but I haven't had time to comment it (kinda trying to build a robot at the moment). - RyanCahoon [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#2
24-01-2009, 16:12
|
|||
|
|||
|
Re: Driver station problem
Did you build and deploy an application to the cRIO and set it to "run at startup"? If not, you'll need to reconnect to the cRIO via laptop or PC (through the DS-side router is fine) and download a new application.
Without build/deploy/"run at startup", the cRIO will always lose its code during a power cycle (hence the DS display of "no code"). I'm guessing that this is your issue. You might want to check out the LabVIEW reference docs here - http://www.usfirst.org/community/frc....aspx?id=10934 Russ 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dead Driver Station? | tdeprince | FRC Control System | 3 | 12-02-2009 12:14 |
| Problem Downloading Program from WindRiver to Driver Station | The_Laughing_ManMII | C/C++ | 10 | 09-01-2009 20:03 |
| Driver Station Blank Screen, Anyone have the same problem? | LDavies562 | FRC Control System | 14 | 22-12-2008 19:34 |
| Driver Station Help.. | 1708xMr.Roboto | FRC Control System | 8 | 22-12-2008 15:24 |
| Driver Station Setup?? | Team 1708 Dave | Programming | 9 | 19-12-2008 23:09 |
Threaded Mode