|
|
|
 Dear Mr. Lavery,
Congratulations. For the fourth year running, you have successfully ruined my Christmas holiday with your untimely release of a most obfuscating, but no less tantalizing, hint. - dubious elise [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
26-01-2009, 09:14
|
|||
|
|||
|
Re: Accerometer Problems
We had a similar problem with ours. I believe it was a software issue. Unfortunitly I cant remember what I had to do to fix it.
You can verify the accelerometer is working by using a voltmeter. With the accelerometer hooked up, measure the voltage between the signal pin and ground. Be careful not to short anything out. If you measure something around 1.5V (+/-0.3V) then it is working. Hope that helps. Jeff 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DS Problems | popo308 | FRC Control System | 3 | 05-01-2009 22:16 |
| OI Problems | spc295 | Technical Discussion | 4 | 05-02-2008 09:44 |
| Labview problems and code problems | ajsetter | Programming | 25 | 18-01-2006 17:07 |
| PC problems. . . | opnickc | IT / Communications | 5 | 12-01-2005 16:53 |
| Problems- | archiver | 1999 | 0 | 23-06-2002 23:00 |
Threaded Mode