|
|
|
 I was not looking at this as a backdoor to asking Brandon to do it (when I have impossible/unreasonable tasks I want done, I ask him straight out ;-) - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I was not looking at this as a backdoor to asking Brandon to do it (when I have impossible/unreasonable tasks I want done, I ask him straight out ;-) - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
26-01-2009, 18:53
|
||||
|
||||
|
Re: Jumper Connections
The same 5 volt connection that is used to power the camera?
We considered that, but the fact that it was already connected to something and that it was 5 volt (not 6 volt as said in the manual) convinced us otherwise. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Benchtest Jumper Question | Lord_Jeremy | FRC Control System | 1 | 07-01-2009 23:09 |
| Ordering a center jumper | BQuennell | Electrical | 3 | 27-02-2007 15:08 |
| PWM 2 pin jumper | mechanicalbrain | Electrical | 4 | 18-12-2005 18:09 |
| Brake/Coast Jumper | archiver | 2001 | 3 | 24-06-2002 01:04 |
| broken jumper on controller | Mike Soukup | Technical Discussion | 5 | 22-10-2001 20:49 |
Threaded Mode