|
|
|
 Our strong support is the result of 14 years of very organized "nagging". :) - OZ_341 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Our strong support is the result of 14 years of very organized "nagging". :) - OZ_341 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
26-01-2009, 23:08
|
||||
|
||||
|
Re: Quick release
1391 used a 1 inch pneumatic piston to hold back our launcher in overdrive. I think we had about 300lbs force held back by a simple lever actuated by the one inch piston.
Depending on the device you are trying to hold back, there are so many ways to do it with pre-made devices but I would recommend just throwing something together that does the job and that is simple and easy to make another one of at a competition. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Bike quick release part 2 | falconmaster | Extra Discussion | 4 | 24-01-2008 07:39 |
| Quick Vacuum Release | Calvin_1631 | Pneumatics | 8 | 05-02-2007 20:49 |
| Quick release wire harness | mechanicalbrain | Electrical | 2 | 08-01-2006 15:36 |
| openFIRST Release -- 'Twas the Release Before Christmas | Timothy D. Ginn | FIRST-related Organizations | 3 | 25-12-2003 23:44 |
| Quick release battery connector and 120 amps | n[ate]vw | Electrical | 6 | 18-01-2003 23:41 |
Threaded Mode