pic: Robot Bumpers

[Jared Russell]

There is no way (in my opinion) that this is a legal frame. The GDC has clearly and repeatedly stated through the Q&A that all bumper perimeter corners must be protected on both sides by a bumper segment of at least 6 inches. You are taking an enormous risk if you play the "it's not a rule" card.

Rules don't trump other rules, ALL rules must be obeyed. There is no way that the configuration shown meets all of the rules set forth by the GDC. We went through this same process with concave openings on the front of the machine (see this), and the GDC was firm in reaffirming that the rules are the rules.

Hopefully the GDC responds to your question clearly and unambiguously, but we've been snakebitten by the letter of the law before. Good luck!