Why is it telling me no code....

programmr · #1 28-01-2009, 08:08

Hello, here is my situation... i am using windriver and i download code to the robot, and reboot and then it says no code..... i try the same exact code, without any code for relays in it, and it works. I can build both codes with no errors. What am i doing wrong? Please help... thank you.

Jared Russell · #2 28-01-2009, 08:13

Make sure both your cRIO and your Workbench/LabView are updated to the most recent version.

programmr · #3 28-01-2009, 08:16

they are, i updated the cRIO to v7, and windriver workbench to update number 3... any other possibilities?

Jared Russell · #4 28-01-2009, 08:25

The cRIO needs to be at version v11 in order to work with update #3. v7 was the firmware for update #2.

programmr · #5 28-01-2009, 08:40

oh ... i didn't see that update, thank you very much! Good Lucky this season =]

Jared Russell · #6 28-01-2009, 08:43

No problem - happy programming.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Telling drivers station your alliance	Mike Mahar	FRC Control System	5	17-01-2009 08:43
Any reason why EEPROM code forgets after power off.	PhilBot	Programming	0	31-01-2008 15:09
Telling alliance in the code	Andrew Schreiber	Programming	4	30-01-2008 10:30
Why should I update my 2006 code?	amateurrobotguy	Programming	4	09-01-2007 21:09
Pact of Secrecy (Stop Telling US!)	Joe Matt	Rules/Strategy	17	30-01-2002 01:02