Riveting for speed - Chief Delphi

I can't get anyone on the team to leave warm South Florida to go to Manchester in January. Go figure. - Warren Boudreau [more]

		Chief Delphi > FIRST > General Forum
Riveting for speed

Thread Tools

Rating:

Display Modes

#14

28-01-2009, 20:06

Paul Copioli Paul Copioli is offline

President, VEX Robotics, Inc.

FRC #3310 (Black Hawk Robotics)

Team Role: Engineer

Join Date: Jun 2001

Rookie Year: 2000

Location: Rockwall, TX

Posts: 1,382

Paul Copioli has a reputation beyond repute

Re: Riveting for speed

Here is our cross section. I am too tired to make a special picture so here is a direct shot from our solid model. The total height is 6", the bottom of the large angle is riveted to the bottom of the frame and the flat part is riveted to the side panel.

Attached Thumbnails

Click image for larger version

Name: bumper.jpg
Views: 429
Size: 61.7 KB
ID: 7255

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Disney & Lockheed team up (in 1942!!) - Flush Riveting.	Elgin Clock	Technical Discussion	2	07-08-2008 00:31
Riveting up a frame	Billfred	Technical Discussion	27	19-12-2006 19:49
Program for variable speed	cabbagekid2	Programming	5	12-01-2005 13:20
Is there a Need for Speed???	Todd Derbyshire	Rules/Strategy	31	19-01-2004 15:43
The Need for Speed?	archiver	2000	4	23-06-2002 22:20

All times are GMT -5. The time now is 22:54.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.