pic: Team 2415 is half way done!

[RMS11]

Originally Posted by s_forbes

Looks shockingly similar to ours... 1557 just posted a picture of their robot, too, and it uses the same method of moving balls up. I wonder how many robots like this we'll see this year?

Probably a lot. It is a very effective design that blends in ball rising and a hopper. If you have a shooter, how do you load it? Upward or to the side?

[FIXIT]

Originally Posted by RMS11

Probably a lot. It is a very effective design that blends in ball rising and a hopper. If you have a shooter, how do you load it? Upward or to the side?

Do you plan to shoot from the top -- seems you have plenty of room?

[s_forbes]

Originally Posted by RMS11

Probably a lot. It is a very effective design that blends in ball rising and a hopper. If you have a shooter, how do you load it? Upward or to the side?

We move balls to the shooter out the top of our helix, as can be seen in this video. It cuts down a little on hopper space, but gives us turreting capabilities.

[RMS11]

Originally Posted by s_forbes

We move balls to the shooter out the top of our helix, as can be seen in this video. It cuts down a little on hopper space, but gives us turreting capabilities.

Yes, we load up to to give us the freedom to rotate the turret.

[Coach Norm]

What is the tube made of? We have been searching and testing different materials for ball bins on our robot.

[XXShadowXX]

Nice and clean design, just a few issues

How did you over come the balls sliding out the bottom, and how do you get balls to go inside of it, if my understanding is correct wouldn't the central spiral need to spin fast enough to hold the balls in, and any faster wouldn't it push them out the top, just wondering.

[RMS11]

Originally Posted by Coach Norm

What is the tube made of? We have been searching and testing different materials for ball bins on our robot.

1/16" plexi. As for the issue of keeping the balls in, that will require some testing but our roller/drive is made with "universal" holes so we can slide it forward and backward in 3/8 " increments so if the balls have problems staying in we can just slide the roller back to keep the balls in.

[amariealbrecht]

That is very cool. I like the clear appeal on the robot. So just a quick question on the blue roller in the front...what kind of material is that made out of and that is the way you are getting the orbit balls into your spiral correct?
Best of luck in your competitions!
Alicia Albrecht
Electrical Subteam
The Robettes 2177