|
|
|
 This place is much brighter than most institutions I have seen. It also seems to be lacking straight jackets which I think is a mistake for many of us. - Andrew Schreiber [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pic: twenty zera niner hub
|
|
#2
29-01-2009, 01:14
|
|||
|
|||
|
Re: pic: twenty zera niner hub
What platform did you render this in? If it's Inventor, you might want to check the resolution settings, as you should be able to clean this up a lot. Solidworks has similar settings.
Poke around, there's much to be learned from the rendering engines in each!
|
|
#3
29-01-2009, 13:03
|
|||
|
|||
|
Re: pic: twenty zera niner hub
Unless you have already made these, I would recommend you put a fillet in there.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 2009 Mecanum Hub - Team 1595 | willson.thomas | Extra Discussion | 23 | 06-11-2008 17:02 |
| Sprocket with hub or without? | Vikesrock | Technical Discussion | 5 | 15-01-2008 01:14 |
| Hub for Wheel attachments | Lavapicker | Kit & Additional Hardware | 5 | 09-01-2007 19:27 |
| Grants awarded to Twenty-seven Schools for FIRST Robotics Program | KathieK | FIRST In the News... | 13 | 19-12-2006 20:58 |
| Re: Connecting hub sprockets to shafts | archiver | 2001 | 1 | 24-06-2002 00:20 |
Linear Mode
