|
|
|
 Engineering is all about trade offs. You can design yor system to do A, B or C easily. Combining A abd C or A and B or B and C requires some effort. Combining A, B and C should be near impossible. - Mike Betts [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
29-01-2009, 16:50
|
||||
|
||||
|
Re: v11 cRIO Image Error
Yep, I tried a full power down and made sure the reset switch is off. I'm still getting the "IP Adress error make sure your IP Reset switch is off" deal.
Currently, my cRIO's name is "temp" and it's IP is 0.0.0.0...and its not letting me image the v11 image. Edit After aquiring a mind of its own, the cRIO has suddenly come up with the IP 10.17.10.2 (1710 is our team name). The name is still temp. My static IP is set to 10.17.10.2 with a subnet of 255.0.0.0. I'm now getting this error with the imager: The specified IP address is unreachable. Ensure that the IP address is on the correct subnet. The specified subnet for use according to section 5.1.2.3 in the manual says "255.0.0.0" soooo is should be working. Unfortunately its not. Any ideas? Last edited by Team1710 : 29-01-2009 at 17:14. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRio Stand-alone Image Tool | Vikesrock | FRC Control System | 3 | 29-01-2009 19:38 |
| CRIO Error 60 | seanl | FRC Control System | 14 | 18-01-2009 16:29 |
| Unable to re-image cRIO | slavik262 | FRC Control System | 4 | 09-12-2008 21:05 |
| Error in code light on, trouble finding error | Bryan Herbst | Programming | 16 | 12-10-2007 21:59 |
| stupid Array error: Error [1300] stack frame too l | Validius | Programming | 7 | 27-01-2006 10:53 |
Threaded Mode