New Programer, have run inot some little blocks

Just wear your safety glasses. They can be stylish, too! - Eugenia Gabrielov [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
New Programer, have run inot some little blocks

Thread Tools

Rate Thread

Display Modes

29-01-2009, 19:51

Wayte

Registered User

FRC #2413

Join Date: Jan 2009

Location: Arizona

Posts: 5

Wayte is an unknown quantity at this point

New Programer, have run inot some little blocks

Ok i knows there's a way to tell the robot to go a certain speed with the programming. I've made a loop to make the number for the speed, but what do I wire that number to to make the robot go that speed?

__________________
Remember there are 3 ways to solve any problem:
1. The easy way
2. The hard way
3. With fire

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
does anybody have any info on an arm that can run on air lines	Evil Asian	Technical Discussion	1	05-03-2007 13:48
An apology from someone a little foolish, a little selfish, and a little inconsiderat	Ken Leung	General Forum	16	01-11-2006 10:07
How many RC5-72 blocks have you completed?	Billfred	Chit-Chat	0	19-08-2004 13:18
Dear Dr. Joe, Can we have a little drill help please?	archiver	2000	1	23-06-2002 22:56

All times are GMT -5. The time now is 11:45.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.