|
|
|
 Yes, you are correct. Even when all other databuses are totally out of bandwith, the PainInTheCalf Bus gets top priority. Good thinking ;-) - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Yes, you are correct. Even when all other databuses are totally out of bandwith, the PainInTheCalf Bus gets top priority. Good thinking ;-) - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Servo's won't power up...
I have been trying to get these servos on the camera gimbals to move for quite some time, but I cant even manage to get them power... The jumper is in place, on 9 and 10 in the PWM outputs, however, the servo's aren't moving, not even centering when the robot is turned on. I have used both the TwoColorDemo and made my own routine to move the servo's, but nothing...
Any ideas? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Do Servo's reset during start up? | ttldomination | FIRST Tech Challenge | 16 | 27-01-2009 18:25 |
| Camera won't initialize when reset from RC - reset from OI and Power-up works, | krunal | Programming | 7 | 15-01-2007 00:13 |
| In a Pickle: Servo's stay at 127 | vector023 | Programming | 11 | 14-02-2006 17:54 |
| EDU won't power up. | actorindp | Robotics Education and Curriculum | 4 | 12-02-2004 22:20 |
| Servo's and EduBots? | DanL | Motors | 6 | 13-01-2003 10:11 |
Threaded Mode