P60 planetaries gearboxes

[banebots]

In response to post #13 by Jacob Plicque

The same problem could exist on all of our planetary gearboxes. In general there is only so much room for the pinion; if the pinion extends beyond it, the gearbox will bind or jam when the screws holding it together are tightened. The measurement should be similar for the 42mm gearboxes. It is likely a little less for the 36mm gearboxes – we will need to look it up.

In response to post #14 by RyanS

The corner holes are 0.59 inch from the center line of the gearbox. If you prefer polar coordinates, center of holes is 0.840 inch from the center of the gearbox, holes are 90deg apart. Knowing that a picture will be much more helpful, we will try and get the drawing updated as soon as possible.

BaneBots