New Laview Update Help

[mjcoss]

We're having the same issue with our system. I update to update 3 last night, and now Labview is broken. It does seem to be isolated to Labview in that if I switch to WindRiver, the Jaguars and servos work just fine. I'm not sure if I'm just missing some update or whether there is really an issue with latest update.

I did notice that the update on the WPI website is different than the one on NI site.

Sorry I couldn't be more help. But misery loves company.

[BLAQmx]

At NI we've updated all of our cRIO test systems and robots to update 3.0 without issue (5 cRIOs total). Can you be more specific on the behavior and the troubleshooting you have done so far? It is likely there is simply something you are looking over.

[Greg McKaskle]

If you haven't solved the problem yet, make sure that when you reimage the cRIO that you actually hit the checkbox to reformat. I know that I've run the utility and forgotten to do it. If you can't remember for sure, a reformat would have taken fifteen minutes with multiple reboots. Without the checkbox, more like fifteen seconds.

Greg McKaskle

[stevenlu]

I am receiving the same error as everyone else where the code does not deploy, using WindRiver.