Buttons on a Attack 3 Joystick useing LABView

I walked out to the area where the robot was getting ready to move, and there's no room near the robot. I look again, and realize it's all students. - rachakate [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Buttons on a Attack 3 Joystick useing LABView

Thread Tools

Rating:

Display Modes

30-01-2009, 17:16

GunfighterJ GunfighterJ is offline

Registered User

AKA: Joseph

FRC #2450 (RaiderBots)

Team Role: Programmer

Join Date: Jan 2009

Rookie Year: 2008

Location: Minnesota

Posts: 34

GunfighterJ is an unknown quantity at this point

Re: Buttons on a Attack 3 Joystick useing LABView

Quote:

Originally Posted by TotalChaos

As far as the buttons go, nothing. The only difference I know of is the joystick axis output ranges from like -30000 something to +30000 something in increments of 256 or 512 or something around there...

- Austin

The joystick ranges from -1 to 0 to 1. If it is scaled to 127 (which it is set to by default) then the joystick ranges from -127 to 0 to 127. Which gives you a more finer control over a motor.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How do you program joystick buttons in LabVIEW?	darkpheonix	NI LabVIEW	10	13-04-2014 10:20
Joystick buttons access	byteit101	C/C++	3	14-01-2009 19:38
buttons in LabView	Pneumaticsman	NI LabVIEW	4	12-01-2009 18:14
Buttons to Pins on Joystick	yarb65	Electrical	1	24-08-2007 20:39
Assigning Joystick buttons....	archiver	2001	5	24-06-2002 00:59

All times are GMT -5. The time now is 09:01.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.