|
|
|
 It would also level the playing field by bringing the bottom up, rather than the top down. - russell [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It would also level the playing field by bringing the bottom up, rather than the top down. - russell [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
31-01-2009, 08:28
|
|||
|
|||
|
Re: servos not responding to camera code
The camera doesn't use the FPGa at all. Meanwhile the servos need PWMs and are produced by the FPGA.
I think that if you run the dashboard or probe for errors, you will see that your FPGA isn't being loaded because it is an incompatible version. If you see this error, update the image on the cRIO to the latest, 11 I think. Greg McKaskle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Axis Camera responding in the Vision Assistant but not in WindRiver | DanDon | C/C++ | 3 | 11-01-2009 12:50 |
| Camera code not working.... | DemonYawgmoth | Programming | 5 | 11-02-2006 09:21 |
| Camera Not Responding To Code | itzrobz | Programming | 2 | 05-02-2006 12:47 |
| CMUcam default code not responding | Kyveck | Programming | 29 | 26-01-2006 16:25 |
| CMUCam Servos not Responding on Robot | krigby | Programming | 7 | 20-01-2006 23:19 |
Threaded Mode