Reading battery power on Driver station.

BrandonD-1528 · #1 31-01-2009, 13:20

The jumper goes on channel 8 but which two prongs. Sig and + or + and - ?

Alan Anderson · #2 31-01-2009, 19:59

Quote:

Originally Posted by BrandonD-1528

The jumper goes on channel 8 but which two prongs. Sig and + or + and - ?

Quote:

Originally Posted by <R64>

A National Instruments 9201 module must be installed in slot 1 of the cRIO Mobile Device Controller. An analog breakout must be connected to this module. A jumper must be installed on the “Battery Voltage” and “Power” pins on the analog breakout. The analog breakout must be powered from the Power Distribution Panel. Please refer to Section 3.4 of the “FRC Control System Component Data Sheets” for information on these connections.

Chapter 3 Control System Data Sheets can be found at http://www.usfirst.org/frccontrolsystem, under the Control System Manual heading.

EricVanWyk · #3 31-01-2009, 20:09

Quote:

Originally Posted by BrandonD-1528

The jumper goes on channel 8 but which two prongs. Sig and + or + and - ?

Please read the manual. You are at risk of damaging components.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dead Driver Station?	tdeprince	FRC Control System	3	12-02-2009 12:14
Driver Station Update	ExarKun666	FRC Control System	8	15-01-2009 10:39
Driver Station Login	Mr-Shutter	FRC Control System	2	12-01-2009 23:36
2nd Driver Station	bcharbonneau	General Forum	2	09-01-2009 14:19
Reading battery voltage in software	RbtGal1351	Programming	17	21-10-2007 13:07