|
|
|
 Don't worry about someone stealing your ideas...if they're good ideas, then imitation is the sincerest form of flattery. If they're lousy ideas, we'll let you know, so you can work on finding a better idea. win-win! - MrForbes [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Problems running Default LabView Code Version 3.0
We are trying to program our robot in Labview and are not having much success:
In earlier versions we were getting motors/sensors to run fine, but when we upgraded to version 3.0, we cannot get any pwm output, even with the default code. LabView seems to deploy fine and we get no errors in the cRio and the Driver Station, but there is no apparent signal from PWMs 1 and 2 (with joystick connected to USB 1). We applied the firmware upgrade and everything, still with no luck. Anyone else have similar problems? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem deploying/running default code | blaxbb | FRC Control System | 0 | 10-01-2009 11:59 |
| Problems integrating CMUCAM code and IFI Default Code | Windward | Programming | 2 | 06-02-2007 16:48 |
| Problems with Kevin's 2007 default code | bruss6 | Programming | 8 | 19-01-2007 15:42 |
| problems using gyro/adc code with camera default code | tanstaafl | Programming | 7 | 22-01-2006 23:09 |
| Labview problems and code problems | ajsetter | Programming | 25 | 18-01-2006 17:07 |
Threaded Mode