|
|
|
 If you pay attention to every nut job on ChiefDelphi, you'll never reach a decision. - JesseK [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you pay attention to every nut job on ChiefDelphi, you'll never reach a decision. - JesseK [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Conveyor belt help
Actually we finished protyping our conveyour belt yesterday...ill get a pic tomorrow (todays meeting had to be canceled)...but basically its a frame (made it out of plywood) with the bottom of it as a guide and the top is a conveyor made of chef liner...we made the liner with about 8.5 in from the guide to compress the ball a bit...i know this probably made no sense but ill get u a pic tomorrow...i have a link to another teams conveyor ours is a little similar
http://www.youtube.com/watch?v=Wwl8NAO3Upo Good Luck |
|
#2
31-01-2009, 16:50
|
||||
|
||||
|
Re: Conveyor belt help
We are using round belting on our robot and we modeled it using sweeps.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Conveyor Belt | jeetshah | Technical Discussion | 36 | 09-02-2009 15:53 |
| Conveyor Belt | Setsanto | 3D Animation and Competition | 2 | 21-01-2008 20:51 |
| conveyor belt materials? | Salik Syed | Technical Discussion | 7 | 13-02-2006 14:51 |
| Conveyor Belt | Garth1388 | Inventor | 4 | 30-01-2006 13:33 |
| COnveyor belt wheels | sdcantrell56 | Technical Discussion | 4 | 18-01-2006 00:10 |
Hybrid Mode
