|
|
|
 Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. Read the manual. - RoboChair [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
01-02-2009, 16:13
|
|||
|
|||
|
Re: servos not responding to camera code
Probe the error wire on some of the I/O to see if you are getting a version error such that your FPGA isn't version 11, or if you are getting a watchdog error. You can also see errors by running the dashboard.
Greg McKaskle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Axis Camera responding in the Vision Assistant but not in WindRiver | DanDon | C/C++ | 3 | 11-01-2009 12:50 |
| Camera code not working.... | DemonYawgmoth | Programming | 5 | 11-02-2006 09:21 |
| Camera Not Responding To Code | itzrobz | Programming | 2 | 05-02-2006 12:47 |
| CMUcam default code not responding | Kyveck | Programming | 29 | 26-01-2006 16:25 |
| CMUCam Servos not Responding on Robot | krigby | Programming | 7 | 20-01-2006 23:19 |
Threaded Mode