|
|
|
 That Billfred guy is going to pay for this one. - Bcahn836 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| That Billfred guy is going to pay for this one. - Bcahn836 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
01-02-2009, 21:05
|
||||
|
||||
|
Re: Chain
Yea we looked into this but the chain generated only has two gear positions. Two of the chains we are using contact at four points. Another two chains contact at three points. Plus when using those parts we were unable to make the files even visible. They were only visible when selected. If we were to use chain generator using ANSI 40 would this hurt or improve chances for the Autodesk Visualization Award?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chain | hong12891 | Inventor | 8 | 05-02-2007 20:03 |
| Chain Drive chain | Damelvin | 3D Animation and Competition | 2 | 15-02-2005 00:19 |
| 25 or 35 chain? | Alan Ing | Technical Discussion | 24 | 02-03-2003 13:56 |
| Chain and chain breaker source? | kmcclary | Off-Season Events | 4 | 22-10-2001 22:51 |
| chain | Lake Orion | OCCRA | 1 | 30-09-2001 13:20 |
Threaded Mode