|
|
|
 Ahem......"where are the President's safety glasses???" - Travis Hoffman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Ahem......"where are the President's safety glasses???" - Travis Hoffman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Downloading error
I was able to download initial code that made a motor drive but now when I go to download new code to the robot, WindRiver says that new code was downloaded to the cRIO but the robot responds as if no new code was downloaded. Am I downloading the wrong file to the cRIO in the Window --> Preferences drop-down or am I compiling it wrong? I had heard that the .out file should be compiled? Where is this file?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Error on downloading sample codes in Labview | TeamCaution | FIRST Tech Challenge | 4 | 02-12-2008 15:05 |
| Error in code light on, trouble finding error | Bryan Herbst | Programming | 16 | 12-10-2007 21:59 |
| 180:Error: syntax error help! | seanl | Programming | 8 | 04-02-2007 11:31 |
| stupid Array error: Error [1300] stack frame too l | Validius | Programming | 7 | 27-01-2006 10:53 |
| Code error on RC after downloading "bells and whistles" version of Kevins camera code | DanDon | Programming | 6 | 10-01-2006 18:07 |
Threaded Mode