No RSL on Digital Sidecar

shobuda999 · #1 02-02-2009, 16:14

Hi Everyone,

Our team is having a serious problem. our RSL is not lighting up at all. We have ran through the benchtop test, and had everything working wirelessly. We have all the latest Labview updates and have successfully deployed the default code. We have the most recent DS update. When we put our hardware into our robot however we noticed our PWM's aren't getting a signal. After doing some research I realized that our digital side car didn't have the robot status light illuminated at all. We switched it out with the other board in the kit, but we are having the same results. We're beginning to worry that the CRio is dead. All the power lights are on solid green, and we have the board connected to slot four of the CRIO. Has anyone experienced this?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Digital Sidecar Problems	cabbagekid2	FRC Control System	13	31-01-2009 17:23
Digital Sidecar Not Working	tseres	Electrical	9	31-01-2009 17:22
Digital Sidecar Resistor	NinJA999	Electrical	5	30-01-2009 19:53
Fusing for Digital Sidecar (was: HIZZELP)	KilroyLaxer	FRC Control System	4	15-12-2008 20:44
Digital Caliper as a Digital Readout on Small Mill	sanddrag	Technical Discussion	9	13-10-2005 22:51