|
|
|
 Please teams I implore you obey the no saving seats rule. Or at least be very friendly in inviting people to sit with you. - IndySam [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Please teams I implore you obey the no saving seats rule. Or at least be very friendly in inviting people to sit with you. - IndySam [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Banebots Gearbox
Our team was planning on using a multistage conveyor belt system on our robot to bring up to our shooter. The purpose of the multistage (horizontal, curve up, vertical) is to allow storage in these separate belts. These would be around 16-17 inches in length and we are debating on what motor to power the 2" rollers. Would several 100:1 reduction 36mm Planetary Gearmotor RS-545 Motor work well for the job? We would like to have a good amount of torque without sacrificing too much rpm. The link for the motors is shown below.
http://banebots.com/pc/MP-36XXX-545/MP-36100-545 Feedback is strongly encouraged! 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Banebots 42MM 36:1 Gearbox Ratios | Madison | Technical Discussion | 11 | 26-02-2008 19:42 |
| Banebots Gearbox | joesmomh00haha | General Forum | 1 | 17-01-2008 16:57 |
| BaneBots 42mm Gearbox Pinion | Gary Bonner | Motors | 1 | 31-01-2007 13:44 |
| 42 mm Banebots Gearbox | Hunter | Motors | 9 | 13-01-2007 21:52 |
| 2007 BaneBots 52mm Gearbox is posted ! | Ed Sparks | Inventor | 3 | 09-01-2007 07:38 |
Threaded Mode