need help with gyro sensor connection

nathanww · #1 03-02-2009, 23:48

You need 1 pwm for your rate output and 1 pwm for your temp output. They're seperate circuits, so you can't run 5v to the rate side and get a temp output

alaa abo alheja · #2 04-02-2009, 08:46

thank u for ur help.......
u said we need two pwm cables the first to the analog input
where we have to connect the scand pwm cable?

nathanww · #3 04-02-2009, 11:03

Basically, your gyro's i/o should look something like this

Rate o o o
Tempo o o

Each circuit needs a signal output, a 5v input, and a ground. So you wire up the PWMs parallel to the rate/temp labels.

alaa abo alheja · #4 05-02-2009, 10:03

thx for ur help
can anyone put a pic of the gyro with the pwm cable connections ?
the second thing we have the second pwm cable from temp 000 where i have to connect it?

team#1946

Alan Anderson · #5 05-02-2009, 11:59

Quote:

Originally Posted by alaa abo alheja

we have the second pwm cable from temp 000 where i have to connect it?

See my post #2 in this thread.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help With Gyro	Bronson	Electrical	3	10-01-2008 21:09
Need help with gyro turn	magical hands	Programming	2	11-03-2007 21:53
Need help with Gyro = Analog Devices ADXRS150EB	Jack Jones	Technical Discussion	9	18-07-2005 07:00
With gyro need to access ADC for poteniometer	mrozek	Programming	0	21-02-2005 13:39
Need help with Sensor	Hop_of_752	Programming	5	06-02-2004 23:43