Battery Display on DS

Alan Anderson · #5 04-02-2009, 12:16

Quote:

Originally Posted by Boydean

Is the battery voltage suppose to show up next to "Battery" on the DS?

Yes.

Quote:

We have done all these steps and it still says 00.00v but then when we read the analog input of AI8 it comes up as 7(ish)v which is about 40% of the 12v(as stated in the Q&A right below).

7(ish) is not 40% of 12.

Are you certain you have battery power coming from the Power Distribution to the Analog Breakout? Measure on the white WAGO connector on the breakout to make sure. You might have one of the WAGO connections hitting the insulation instead of the conductor on an insufficiently-stripped wire.

(Note that you must use a 20A breaker, not a 5A one.)

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Interacrtive Display	PUFIRST	Chit-Chat	1	09-04-2008 15:29
OI Display problem?	Shu Song	Control System	4	01-02-2005 20:42
OI Display problem?	Shu Song	Electrical	4	01-02-2005 20:42
Battery Charger for long term battery care	DougHogg	Kit & Additional Hardware	0	08-02-2003 15:25
LCD display	James Crivellone	Rules/Strategy	6	06-01-2002 10:22