|
|
|
 I would go even further and say always hate your robot. Keep breaking, iterating, and trying to figure out how to change the robot from week one of build season to champs. - saikiranra [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
04-02-2009, 14:58
|
|||
|
|||
|
Re: Wire Gauge vs Length (Signal)
I'd be very surprised if your digital signals suffered from resistive drop. Also, FIRST uses some very slow signals, so I again wouldn't panic.
For more information on the GPIO signal pins, you should look up the NI 9403's Operating Instructions and Specifications. For information on the power supply capabilities of the DSC, look in section 3 (page 27) of the control system manual. I'd be much more concerned with the amount of noise coupled in over those 14 foot runs. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Signal wire gauge and color. | sparrowkc | Electrical | 4 | 10-03-2010 19:51 |
| Spike Relay Wire Gauge | sparrowkc | Electrical | 7 | 12-02-2008 14:26 |
| Wire gauge vs. current | AdamHeard | Electrical | 7 | 09-11-2007 10:36 |
| Wire Gauge Question | Neghman | Electrical | 1 | 14-02-2004 19:56 |
| 11 Gauge Wire...where? | Matt Krass | Electrical | 6 | 21-01-2003 10:17 |
Threaded Mode