heat gun

Lake Orion · #1 16-10-2001, 18:01

can we use a heat gun. there is no way to use shink tubing with out a heat gun.

thank you
lake orion

Mike Martus · #2 18-10-2001, 08:00

If the purpose is to use as a heat source for shrink wrap, then a hairdryer works easier and is much safer. Also a match or lighter is appropriate. I have even seen teams use a soldering gun as the heat source.

Matt Attallah · #3 21-10-2001, 23:34

Yes, hair dryer is a total go! (haven't tested it out, but the basic fundamentals are the same) And we have used a lighter, but that is a no.... (Burnt some plastic, didn't smell too good!)

View Poll Results: on a scale of 1-10 rate how you team is doing with buildinging your robot
1 bad	0	0%
2	0	0%
3	1	6.67%
4	0	0%
5	0	0%
6	2	13.33%
7	2	13.33%
8	2	13.33%
9	2	13.33%
10 great	6	40.00%
Voters: 15. You may not vote on this poll

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MD State Fair	Wetzel	Off-Season Events	17	17-01-2004 20:05
Build a Ion Ray Gun	MattK	Chit-Chat	12	20-09-2003 14:07
'IT' info...	archiver	2001	19	24-06-2002 01:58
heat sinks	archiver	2000	1	23-06-2002 22:45
New IT info?	Mike Soukup	Dean Kamen's Inventions	10	08-12-2001 23:03