|
|
|
 So the bar is set insanely high. Probably unachievably high for some of us. But what a shame it would be to lower it. - pfreivald [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| So the bar is set insanely high. Probably unachievably high for some of us. But what a shame it would be to lower it. - pfreivald [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#6
06-02-2009, 01:18
|
|||
|
|||
|
Re: pic: Toughbox Gear, destroyed
we have had similar tolerence problems from AM products, we had an extended shaft strip the hex part, it must have not been heat treated.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Universal Chassis with Toughbox Adapters | ajlapp | Extra Discussion | 1 | 28-12-2008 23:19 |
| pic: 1024's Toughened Toughbox | Qbranch | Extra Discussion | 3 | 19-02-2008 21:01 |
| toughbox gear/shaft slippage | wireties | Motors | 11 | 01-02-2008 12:34 |
| Cubs curse ending? Steve Bartman ball to be destroyed tonight! 2/26 | D.J. Fluck | Chit-Chat | 6 | 26-02-2004 23:15 |
Threaded Mode