|
|
|
 GP is an ideal to live by, but not a tool to judge with. - Rich Kressly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| GP is an ideal to live by, but not a tool to judge with. - Rich Kressly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
06-02-2009, 18:51
|
||||
|
||||
|
Re: How do I load the default code?
HarryScheiner,
1)Did you make sure to Undeploy (Under the same FIRST menu bar entry as Download) before downloading the SimpleTemplate? 2)After downloading, did you reset the robot? 3)Have you connected the cRIO's serial port to your PC via a null-modem connection? Is VxWorks throwing up any error messages to the console as it boots? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The Default Code | robocata | Programming | 1 | 29-01-2006 17:59 |
| Default code and the Compressor | Matthew_H | Programming | 16 | 07-02-2005 07:19 |
| Best Way To Insert Autonomous Code Into Default then load help.? :-)? | gemccnp | Programming | 2 | 05-02-2005 18:58 |
| Can't Compile the Default Code | pressurex1 | Programming | 4 | 25-01-2004 20:26 |
| How long does it take you to load the default code? | vegasmcse | Robotics Education and Curriculum | 10 | 03-11-2003 21:41 |
Threaded Mode