|
|
|
 It’s impossible to know who’s life you will change forever. Don’t miss an opportunity. I’m an optimist. Have a great season. This is the year. - Rich Kressly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It’s impossible to know who’s life you will change forever. Don’t miss an opportunity. I’m an optimist. Have a great season. This is the year. - Rich Kressly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
06-02-2009, 22:27
|
||||
|
||||
|
Re: CRIO HELP!!!
Drill holes in a polycarb sheet matching the size and location of the component. Feed a zip tie up though the bottom on the polycarb and though the mounting hole. If you did not make the hole too big, the head of the zip tie should not pass though the hole as it is too big.
Take another zip tie and push the head onto the zip tie on the component side and tighten down onto the component. Trim both loose ends... |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRIO Imaging Tool HELP PLEASE!!! | furiousgeorge | FRC Control System | 2 | 08-02-2009 22:44 |
| Dead cRIO??!!? HELP!!! | naruto137 | Technical Discussion | 11 | 05-02-2009 23:58 |
| cRio IP change help | mastergamer1231 | Programming | 1 | 03-02-2009 19:38 |
| Help Getting cRIO Feedback | rholokleolke | C/C++ | 3 | 29-01-2009 17:13 |
| Help With Our cRio | DPTeam270Driver | NI LabVIEW | 4 | 25-01-2009 23:37 |
Threaded Mode