|
|
|
 Expect a lot of noise, unexpected things going wrong, and most of all, tons and tons of fun. - nitneylion452 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Expect a lot of noise, unexpected things going wrong, and most of all, tons and tons of fun. - nitneylion452 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#20
06-02-2009, 22:45
|
|||
|
|||
|
Re: Does the PD board Output 12v Stable?
The question was meant to address how regular the power was when taken from the unregulated outputs - I'm not planning to plug the wireless bridge into the unregulated power supply, even if it's regulated power would have supplied a high enough wattage to power the motherboard. The main point of the question was to determine how variable the current/voltage was when taken directly from the unregulated supply. Thx everyone for fully answering the question
 -jonathan |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Reading the 12V Battery voltage in LabVIEW | PhilBot | FIRST Tech Challenge | 7 | 12-01-2009 21:13 |
| hybrid rules are not quite stable.. | zivo123 | General Forum | 23 | 12-03-2008 00:45 |
| Does the IR board have to go in the crate? | dyanoshak | Sensors | 5 | 19-02-2008 14:56 |
| TTL Output on CMU Board | Tom Bottiglieri | Programming | 6 | 24-01-2006 18:35 |
| Does anyone on this board work at home depot? | mnkysp6353 | General Forum | 2 | 30-12-2001 13:27 |
Threaded Mode