|
|
|
 Minus the one time when our Autonomous mode actually reversed, ran into the robot behind us, and lodged them into the rear wall - MysterE [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Minus the one time when our Autonomous mode actually reversed, ran into the robot behind us, and lodged them into the rear wall - MysterE [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
passing image data through vi's
how do we pass the image data through vi's?
we are a rookie team and it would be much appreciated if we could have a little bit of help. Thanks ~Jack in the Bot |
|
#2
07-02-2009, 15:35
|
|||
|
|||
|
Re: passing image data through vi's
The subVI for Find Two Colors passes the image through as an example. There is also a subVI inside that creates lots of images and passes them out.
The control that dose this is an Image refnum, and it is also in the palettes next to the image display. Greg McKaskle |
|
#3
07-02-2009, 15:37
|
||||
|
||||
|
Re: passing image data through vi's
thank you so much.
that was a big help.  ~Jack in the Bot |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LabView Functions Palette missing WPI VI's | ksquared | NI LabVIEW | 1 | 31-01-2009 15:03 |
| Using the analog sensor .vi's | Hazmatt | NI LabVIEW | 5 | 13-01-2009 22:57 |
| How to write image data to binary PGM file format(P5)? | tommy_chai | Programming | 0 | 08-10-2007 08:22 |
| Ball Passing | codeoftherobot | Rules/Strategy | 6 | 12-01-2004 22:26 |
Linear Mode
