How do we open a servo in the Begin.vi

If this was really about changing the culture, FIRST would be on Will.I.Am's website. - Meredith Novak [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
How do we open a servo in the Begin.vi

07-02-2009, 17:08

JeffatJITB JeffatJITB is offline

Registered User

FRC #2910

Join Date: Jan 2009

Location: Mill Creek, WA

Posts: 5

How do we open a servo in the Begin.vi

Hoe do we open a servo in the Begin.vi? We need FAST! Thanks!

Also, if there is anything else we need to do i.e. setup the watchdog to run with the servo, then please let us know!

Last edited by JeffatJITB : 07-02-2009 at 17:15.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Where do I begin to get the robot to move using the camera?	Ianuser	Programming	10	16-02-2007 17:55
Let the AZ Regional Begin!	WakeZero	Regional Competitions	5	12-03-2004 00:18
As the matches Begin	Boilerman31	General Forum	3	07-03-2003 12:19
How do you set a speed limit on the servo	Fares	Programming	6	01-01-2003 15:04
How much do the servo cost?	Ken Leung	Motors	2	14-09-2001 15:42

All times are GMT -5. The time now is 10:36.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.