|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#5
|
|||
|
|||
|
Re: Invalid PWM Channel Index
Actually, the open requires the channel to be wired. Check each Motor open and see that you have the channels wired that you meant to.
If you are using the drive VIs, check those opens. If using servos, check those too. Finally, the next time you run, make sure the dashboard is open. It will show you if you have errors. I suspect that you have an issue where a channel is already in use, produces an error, and then the refnum is invalid. Greg McKaskle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Invalid Address | Farnak | Programming | 4 | 17-04-2008 19:09 |
| Invalid Address | team 803 | Programming | 20 | 21-02-2006 09:10 |
| 2005 Robot Picture Index | Gasperini | Robot Showcase | 9 | 09-04-2005 13:06 |
| IRI popularity index | Joe Ross | Fantasy FIRST | 5 | 03-07-2004 12:36 |
| Metal/Materials/Tools Source Index | dlavery | Technical Discussion | 0 | 12-01-2002 00:36 |