|
|
|
 And while I am not that big on hero-worship, I am pretty darn proud to know Dave. However, this does not mean that I will stop picking on him - MissInformation [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| And while I am not that big on hero-worship, I am pretty darn proud to know Dave. However, this does not mean that I will stop picking on him - MissInformation [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
07-02-2009, 22:29
|
||||
|
||||
|
Re: DIO Signal, Channel, slot, and Vex UltraSonic
I think the ping.vi must be called. Looking inside the GetRange.vi I don't see anything that is causing the Ping to occurr.
Take a look at this post and see if it helps/hurts. http://www.chiefdelphi.com/forums/sh...RIO+ultrasonic Sean 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Signal wire gauge and color. | sparrowkc | Electrical | 4 | 10-03-2010 19:51 |
| DIO not working in autonomous. | adamdb | NI LabVIEW | 10 | 12-02-2009 01:23 |
| Open motor reference on Slot 6 DIO Module | trilogy2826 | NI LabVIEW | 2 | 27-01-2009 08:42 |
| Using DIO pin 14 as timer source? | Jared Russell | Programming | 1 | 12-02-2006 00:02 |
| Robots and the Learning Channel.... | archiver | 2000 | 0 | 24-06-2002 00:16 |
Threaded Mode