|
|
|
 I know my grandmother would call me a bully for that. And she didn't raise a bully. - Libby K [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I know my grandmother would call me a bully for that. And she didn't raise a bully. - Libby K [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
[FTC]: External Battery Setting
Sup,
I was wondering how to charge the battery? Well, more specifically, what amp value do we use to charge the batteries? This is *not* the first time we're charging them, but we had a debate about this and I really wanna know. Thankx. 
|
|
#2
08-02-2009, 15:18
|
||||
|
||||
|
Re: [FTC]: External Battery Setting
I would recommend the low setting for almost all the time. I heard a few people say that their batteries had severe problems if they charged on the 1.8 Amp setting, though that was a while back.
we charge on the .9 Amp setting except when we NEEDED a battery. Like if you juts need to get the voltage up a little bit quickly right before the round, try the 1.8 Amp setting, but the .9 Amp setting is what I recommend just because I heard a few people say that charging completely with the 1.8 Amp setting caused a few (and rare) problems.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Help requested, the NXT is not showing the battery as being connected. | crazilyrandom1 | FIRST Tech Challenge | 2 | 17-01-2009 11:24 |
| paper: Reading the FTC Battery Voltage | PhilBot | Extra Discussion | 4 | 16-01-2009 08:46 |
| [FTC]: Reading the 12V Battery voltage in LabVIEW | PhilBot | FIRST Tech Challenge | 7 | 12-01-2009 21:13 |
| [FTC]: [FTC]: Replacing Fuse for Battery | fqzeng | FIRST Tech Challenge | 4 | 18-11-2008 20:04 |
| [FTC]: [FTC]: Ontario Provincial FTC Start/End Times | cbhl | FIRST Tech Challenge | 8 | 16-12-2007 13:37 |
Linear Mode
