|
|
|
 I know that it's often dangerous to use common sense in a YMTC thread... - Kris Verdeyen [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I know that it's often dangerous to use common sense in a YMTC thread... - Kris Verdeyen [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
08-02-2009, 23:33
|
||||
|
||||
|
Re: 2009 KOP sprocket issues
To echo Madison, we had an issue with (I believe) 35 pitch sprockets from Andymark in the past as well. I informed Andy of the problem, and he send replacement parts that day, free of charge.
We had the same "chain wrap" issue, the chain would seat in a few teeth just fine, but it would eventually fail to mate with the gear. Seems like the Pitch Diameter is off by the slightest amount. Again, Andy should be able to take care of your problems. He has always stood behind his product, and has always been prompt with my experiences with him. Bengineer |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Possible? Converting KOP 2009 Assemblies to Inventor 2008 | 7-11number1 | CAD | 4 | 02-03-2009 21:42 |
| 2009 KoP Double Check | JaredSanMiguel | Motors | 2 | 14-01-2009 18:12 |
| 2009 KOP and Field CAD in Inventor '08/STEP? | Travis Hoffman | CAD | 0 | 14-01-2009 13:36 |
| Missing Parts in 2009 KOP | woogit | General Forum | 13 | 04-01-2009 18:18 |
| 2009 KOP? | excel2474 | Kit & Additional Hardware | 3 | 02-10-2008 17:57 |
Threaded Mode