Camera on basic framework

Arcre · #1 09-02-2009, 03:31

How do I use the camera program on the basic framework for labview projects? Do I need to change ips?

Greg McKaskle · #2 09-02-2009, 09:30

The basic framework has a loop for doing camera stuff. You might want to hook up a display for debugging. Also look at the examples for color tracking, if nothing else to copy a display.

As for the electrical and IP stuff. The camera should be setup using the Camera setup tool according to the directions. Use the orange enet cable between camera and the second cRIO port.

Greg McKaskle

Arcre · #3 11-02-2009, 04:17

Thanks! I will try that, I hope they work.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
declaring a servo in begin.vi (advanced framework)	Christine_Ilich	NI LabVIEW	2	10-02-2009 18:41
Tank Drive with Advanced Framework in Labview	finman	NI LabVIEW	4	30-01-2009 13:35
FRC Framework Guide	Jon236	FRC Control System	0	17-11-2008 18:18
paper: Low Latency Interrupt Framework	dcbrown	Extra Discussion	5	10-02-2008 15:56
Robot Framework	lord Purity	Pneumatics	3	21-01-2007 15:57